机械设计论文网


  • 首页|
  • 机械模具设计论文|
  • 机械模具开题报告|
  • 机械模具免费论文|
  • 机械模具外文翻译|
  • 数控论文|
  • 机械原创论文|
  • 焊工钳工论文|
  • 理工科论文|
         模具专业毕业设计   机械专业毕业设计   数控专业毕业设计

论文降重

当前位置:机械设计论文网 -> 机械模具外文翻译 -> 建模与仿真GPS信号产生和数字信号重建的应用软件

建模与仿真GPS信号产生和数字信号重建的应用软件

本文ID:LW7439

下载地址 全文下载链接(充值:27元) 如何充值?

中文字数:5082,中文页数:8  英文字数:2965 页数:11


作者简介

Alison Brown是公司总裁兼首席执行官,她获得过加州大学洛杉矶分校在力学,航空航天和核工程的博士学位,麻省理工学院航空和航天的理学硕士学位,剑桥大学的文学硕士学位。她于1986年成立NAVSYS.现在她是GPS - Ⅲ(服务于美国空军和全球定位系统)编辑顾问委员会的独立审评组和科学咨询委员会的一员。

Keith Taylor是NAVSYS公司的项目经理。他负责开发基于MATLAB的GPS信号模拟工具,应对用户选择的信号环境和干扰的情况。他持有来自佛罗里达大学的电机工程学硕士学位和路易斯维尔大学的电机工程学士学位。

Neil Gerein是NAVSYS公司的项目经理。他负责快速采集基于GPS接收机系统的FFT(COGNAC) ,并开发Xilinx FPGA的固件和改变CPLD(复杂可编程逻辑器件备)
他目前正在拥有电机工程学士学位萨斯喀彻温省大学,完成他的硕士电气工程专业。

摘要

GPS卫星模拟器试验设施是用来校验全球定位系统接收器和增强系统的软件和硬件的。一般情况下,它们包括卫星信号模拟器,差分放大模拟器和仿真器的接口。所有的测试运行实时需要大量的硬件和人力资产。起初,动态情况下的模拟必须设计并存储在模拟器控制计算机。这种情况下指定好所有有关的因素,包括GPS接收器的轨道,人造卫星的位置,信号功率和波形,环境因素包括传播错误和干扰的影响。一般情况下,在实际测试情况前,要完成大多设备安装和校准。此外,卫星模拟器及控制设备的费用昂贵,通常需要100万美元。

NAVSYS已经开发出一种MATLAB的产品,用软件仿真的复杂环境,来完成全球定位系统建设。这提供了一个高精度模型的GPS信号环境,也可以对收到的GPS信号加入干扰信号源,天线和接收机特性。软件仿真的结果是从一个GPS接收机,在这种环境下,代表数字采样的GPS信号的数字式文件。


Modeling and Simulation of GPS Using Software
Signal Generation and Digital signal Reconstruction
Alison Brown, Neil Gerein, and Keith Taylor, NAVSYS Corporation


BIOGRAPHY

Alison Brown is the President and CEO of NAVSYS Corp. She has a PhD in Mechanics, Aerospace, and Nuclear Engineering from UCLA, an MS in Aeronautics and Astronautics from MIT, and an MA in Engineering from Cambridge Univ. In 1986 she founded NAVSYS.Currently she is a member of the GPS-III Independent Review Team and Science Advisory Board for the USAF and serves on the GPS World editorial advisory board.

Keith Taylor is a Project Manager for NAVSYS Corporation. He is responsible for developing MATLAB based GPS signal simulation tools for user selectable signal environments and jamming scenarios. He holds an MSEE from University of Florida and a BSEE from the University of Louisville.

Neil Gerein is a Project Manager for NAVSYS Corporation. He is responsible for a rapid acquisition FFT based GPS receiver system (COGNAC) and has developed firmware for Xilinx FPGAs and Altera CPLDs.He is currently completing his M.Sc. in Electrical Engineering and holds a BSEE in Electrical Engineering from the University of Saskatchewan.

ABSTRACT

GPS satellite simulator test facilities are used to checkout the software and hardware of GPS receivers and their augmentation systems. In general, they include satellite signal simulators, differential augmentation simulators and interface emulators. All testing is run in real time and requires considerable hardware and human assets. Initially, the dynamic scenario to be simulated must be designed and stored in the simulator control computer. This scenario specifies all relevant factors including the trajectory of the GPS receiver(s), the satellite constellation, the signal power and waveforms, environmental factors including propagation errors, and jamming effects. In general, there is considerable equipment setup and calibrations that must be performed prior to actually exercising the scenario. In addition, the satellite simulator and control equipment are expensive resources typically costing on the order of one million dollars.

 

本站会员可自行下载:下载地址 建模与仿真GPS信号产生和数字信号重建的应用软件 (收费:2700 积分)  如何获取积分?
建模与仿真GPS信号产生和数字信号重建的应用软件相关论文
论文人工降重
本论文在机械模具外文翻译栏目,由机械设计论文网整理,转载请注明来源 www.jixielw.top 更多论文,请点机械设计论文网查看
上一篇:沥青路面的铺设 下一篇:抗侧力结构体系
推荐论文 本专业最新论文

点击查看关于 建模 仿真 GPS 信号 产生 数字 重建 应用软件 的相关论文题目 2010-06-11 19:43:46【返回顶部】
联系方式

相关栏目

数控专业论文
机械设计原创毕业论文
机械模具毕业设计论文
焊工钳工技师论文
机械模具开题报告
理工科论文下载
机械模具免费论文
机械模具外文翻译
联系方式


联系方式


机械设计论文网提供机械设计论文范文,行政管理毕业论文,网站永久域名www.jixielw.top 

本站部分文章来自网友投稿上传,如发现侵犯了您的版权,请联系指出,本站及时确认并删除  E-mail: 17304545@qq.com

Copyright@ 2009-2021 机械设计论文网 版权所有